Fused Alternator Charge Cable Kit

This kit is for making the connection from the alternator to either the starter solenoid or the battery disconnect switch. The solder-on terminals are supplied loose to allow you to cut the 8-gauge cable the length required for your alternator and solenoid locations and cable routing. A 125Amp Bolt-Down Fuse and holder are supplied. If you are connecting to your battery disconnect switch you will use the 3/8” loop crimp terminal. The 1/4″ flexible wire loom supplied is nylon which is distinguished by a gray stripe and is rated for up to 300F. Includes solder slugs, heat shrink tubing, and fasteners. Note: For alternators with 1/4″ stud output terminal. Not for 2G Ford Alternators. Recommended to replace the non-fused wiring in the FFR/Ron Francis harness when upgrading to a 3G or other alternator.